Harrison Design Flat Face triggers are manufactured to offer the shooter a 1911 trigger with features that will allow years of reliable, comfortable service.
Each Extreme Service trigger is made with hardened stainless steel bows that are micro-polished to reduce friction.
The solid aluminum shoes are oversize in height allowing fitting to the individual pistol.
The flat face triggers measure ~.450" as shown in the picture.
The "B" trigger is treated with Black DLC coating, for an all-black trigger.
The "N" trigger is natural aluminum and stainless steel for an all silver trigger.
The squared off face of the trigger shoe is smooth with a radius from side to side, so your trigger finger doesn't feel any sharp square corners where the face meets the sides. The face is free from serrations and holes for the over-travel screw that can chafe and abrade your trigger finger during long training sessions.
DO NOT attempt to turn the over-travel screw! The over-travel screw is permanently locked in place so it can't creep and render your pistol inoperative in an emergency. The initial adjustment to the over-travel stop is made by filing the tip and re-testing until the correct amount of over-travel is achieved.
The H-D Flat Face Trigger has a length of pull equivalent slightly shorter than on our long trigger.
Note that fitting by a knowledgeable installer is required to install this part.
